Geotech-informed

Slab settlement & heave investigation

A floor out of level has three possible stories: the slab settled, reactive clay heaved beneath part of it, or the slab was built that way. Each story leads somewhere different. Level surveys, moisture readings and a look at the site's drainage history separate them before any remediation is priced.

Scope

What this covers

  • Floor level surveys establishing the shape and direction of movement

  • Moisture profiling around the slab edge to find wetting and drying drivers

  • Review of geotechnical information and the site classification where available

  • Relevelling options analysis: grout injection, resin, or targeted footing work

  • Written findings an engineer can adopt into a remediation design

Timing

When it's needed

Sloping or springy floors, tile cracking that follows straight lines, skirting boards lifting off the floor, or a slab edge that has visibly dropped relative to paving. Heave commonly shows after plumbing leaks, redirected stormwater or tree removal changed the moisture balance under the slab.

Sudden large cracks, walls visibly out of plumb, or masonry that sounds hollow and drummy overhead can indicate unstable structure. Keep people away from affected areas, avoid slamming doors in distressed walls, and seek urgent engineering advice rather than waiting for a routine appointment.

Quote variables

What shapes the scope

Foundation and footing remediation in NSW is building work: contractors must hold the appropriate NSW contractor licence for the work performed, and structural repairs should be designed or verified by a practising structural engineer, with geotechnical input where founding conditions are in question. Ask to see licence details and the engineer's documentation before committing.

Repair scopes

Start your quote

Send through the job details and we'll connect you with a licensed provider who can quote this work.

If this is an emergency or anyone is at immediate risk, contact the relevant emergency service or your network or utility operator directly instead of using this form.